Pioneer VSX-917V-S User Manual - Page 27
Character display LCD - reset
View all Pioneer VSX-917V-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Controls and displays 04 English Deutsch Français Italiano Nederlands Español STANDARD - Press for Standard decoding and to switch between the various Pro Logic IIx and Neo:6 options (page 28). ADV.SURR. - Use to switch between the various surround modes (page 29). PHASE - Press to switch on/off Phase Control (page 10). ACOUSTIC EQ - Press to select an Acoustic Calibration EQ setting (page 31). DIALOG - Use to make dialog stand out when watching TV or a movie (page 32). SOUND RETRIEVER - Press to restore CD quality sound to compressed audio sources (page 32). 9 SHIFT Press to access the DVR controls (above the component control buttons) as well as some receiver controls. 10 INPUT SELECT Use to select the input source (use SHIFT for INPUT SELECT ). 11 SOURCE Press to turn on/off other components connected to the receiver (see page 50 for more on this). 12 Character display (LCD) This display shows information when transmitting control signals. The following commands are shown when you're setting the remote to control other components (see Controlling the rest of your system on page 50): SETUP - Indicates the setup mode, from which you choose the options below. PRESET - See Selecting preset codes directly on page 51. DIRECT F - See Direct function on page 52. ERASE - See Erasing one of the remote control button settings on page 51. RESET - See Erasing all of the remote control presets on page 51. READ ID - See Confirming preset codes on page 52. 13 RECEIVER Switches the remote to control the receiver (used to select the green commands above the number buttons (DIMMER, etc)). Also use this button to set up surround sound (page 8, page 36). 14 VOL +/- Use to set the listening volume. 15 MUTE Mutes the sound or restores the sound if it has been muted (adjusting the volume also restores the sound). 16 EFFECT/CH SEL Press repeatedly to select a channel, then use +/- to adjust the level (see Tip on page 44). Also adjusts the level of the Advanced Surround effects, Dolby Pro Logic IIx Music, and Neo:6 Music parameters (page 29). You can then use the +/- buttons to make these adjustments. Operating range of remote control The remote control may not work properly if: • There are obstacles between the remote control and the receiver's remote sensor. • Direct sunlight or fluorescent light is shining onto the remote sensor. • The receiver is located near a device that is emitting infrared rays. • The receiver is operated simultaneously with another infrared remote control unit. 30 30 DOWN DOWN 7 m 27 En