Pioneer VSX-917V-S User Manual - Page 69
Additional information, Power cord caution, Cleaning the unit
View all Pioneer VSX-917V-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Additional information 13 English Deutsch Français Italiano Nederlands Español • Frequency response DVR/VCR, DVD/LD, TV/SAT MONITOR. . . . . . 5 Hz to 7 MHz dB Signal-to-Noise Ratio 55 dB Crosstalk 50 dB Component video section • Input (Sensitivity/Impedance) DVD/LD, TV/SAT, DVR/VCR 1 Vp-p/75 Ω • Output (Level/Impedance) MONITOR OUT 1 Vp-p/75 Ω • Frequency response DVD/LD, TV/SAT, DVR/VCR MONITOR ..... 5 Hz to 40 MHz dB Signal-to-Noise Ratio 60 dB FM Tuner Section Frequency Range 87.5 MHz to 108 MHz Usable Sensitivity Mono:13.2 dBf, IHF (1.3 µV/ 75 Ω) 50 dB Quieting Sensitivity Mono: 20.2 dB Stereo: 38.6 dBf Signal-to-Noise Ratio...... Mono: 73 dB (at 85 dBf) Stereo: 70 dB (at 85 dBf) Distortion Stereo: 0.5 % (1 kHz) Alternate Channel Selectivity 60 dB (400 kHz) Stereo Separation 40 dB (1 kHz) Frequency Response 30 Hz to 15 kHz (±1 dB) Antenna Input (DIN 75 Ω unbalanced AM Tuner Section Frequency Range 531 kHz to 1602 kHz Sensitivity (IHF, Loop antenna 350 µV/m Signal-to-Noise Ratio 50 dB Antenna Loop antenna Miscellaneous Power requirements AC 220 V to 230 V, 50 Hz/60 Hz Power consumption 395 W In standby 0.5 W Dimensions 420 (W) mm x 158 (H) mm x 352.5 (D) mm Weight (without package 8.8 kg Furnished Parts Microphone (for Auto MCACC setup 1 Dry cell batteries (AA size IEC R6 2 Remote control 1 AM loop antenna 1 FM wire antenna 1 Warranty card 1 These operating instructions Note • Specifications and the design are subject to possible modifications without notice, due to improvements. Power cord caution Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or an electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it damaged, ask your nearest Pioneer authorized service center or your dealer for a replacement. Cleaning the unit • Use a polishing cloth or dry cloth to wipe off dust and dirt. • When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers. • Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface. 69 En