Pioneer VSX94TXH Owner's Manual - Page 75

Using other functions 11 Checking your system settings Use the status display screen to check your current settings for features such as surround back channel processing and your current MCACC preset. AUDIO SUBTITLE HDD DISP CH PHOTO T.DISP STATUS SIGNAL SEL SBch DVD CH STEREO/ F.S.SURR MULTI OPE THX STANDARD ADV. SURR SHIFT PHASE MCACC S.DIRECT 1 Press STATUS to check the system settings. These appear on the front panel display.1 The front panel display shows each of the following settings for two seconds each: Input source ↓ Surround Back Processing ↓ MCACC preset ↓ ZONE 2 / REC SEL ↓ ZONE 3 ↓ HDMI Control 2 When you're finished, press STATUS again to switch off the display. Resetting the system Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. 1 Switch the receiver into standby. 2 While holding down the SETUP button on the front panel, press  STANDBY/ON. The display shows RESET NO. 3 Press the ENTER button on the front panel. 4 Select RESET using /, then press the ENTER button on the front panel. The display shows RESET? OK. 5 Press ENTER to confirm. OK appears in the display to indicate that the receiver has been reset to the factory default settings. • Note that all settings will be saved, even if the receiver is unplugged. Default system settings Setting Default HDMI Audio Amp Digital Video Conversion On Speakers A Surround Back System Normal (default) Speaker System Front SMALL Center SMALL Surr. SMALL SB SMALLx2 SW YES Crossover 80 Hz X-Curve OFF THX Audio Setting 0-1ft. Inputs See Input function default and possible settings on page 68. MULTI-ZONE Zone 2 Volume Type Variable Zone 2 Volume -60 SR+ SR+ Control On/Off OFF SR+ Volume Control On/Off OFF Note 1 If the Pure Direct mode is switched on, some settings above will show OFF, even though they are on. 75 En