Pioneer X-HM10-K Operating Instructions - Page 43

Connecting up 02 English Français Deutsch Italiano Español Nederlands Use the PRE OUT outputs to connect the surround back speakers Connect the PRE OUT outputs of the system and additional amplifier to add a surround back speaker. 1 2 Surround back speakers SBL SBR R ANALOG L AUDIO IN Surround back channel amplifier • You can use the additional amplifier on the surround back channel pre-outs for a single speaker as well. In this case plug the amplifier into the left (L (Single)) terminal only. Plugging in the system Only plug in after you have connected all your components to this system including the speakers. 1 Plug the supplied power cord into the AC IN socket on the back of the system. 2 Plug the other end into a power outlet. CAUTION • Handle the power cord by the plug part. Do not pull out the plug by tugging the cord, and never touch the power cord when your hands are wet, as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, or other object on the power cord or pinch the cord in any other way. Never make a knot in the cord or tie it with other cables. The power cords should be routed so that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electric shock. Check the power cord once in a while. If you find it damaged, ask your nearest Pioneer authorized independent service company for a replacement. • Do not use any power cord other than the one supplied with this unit. • Do not use the supplied power cord for any purpose other than that described above. • The system should be disconnected by removing the mains plug from the wall socket when not in regular use, e.g., when on vacation. 43 En