Pioneer X-HM10-K Operating Instructions - Page 73
Speaker Setting, Channel Level, SP Setup menu.
View all Pioneer X-HM10-K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
The System Setup menu 08 English Français Deutsch Italiano Español Nederlands 1 Select 'Manual SP Setup' then press ENTER. System Setup 1.Auto MCACC 2.Manual SP Setup 2.Manual SP Setup a.Speaker Setting b.Channel Level c.Speaker Distance Return Return 2 Select the setting you want to adjust. If you are doing this for the first time, you may want to adjust these settings in order: • Speaker Setting - Specify the number of speakers you've connected (see below). • Channel Level - Adjust the overall balance of your speaker system (see below). • Speaker Distance - Specify the distance of your speakers from the listening position (see page 74). 3 Make the adjustments necessary for each setting, pressing RETURN to confirm after each screen. Speaker Setting Use this setting to specify your speaker configuration (number of speakers). It is a good idea to make sure that the settings made in Automatically setting up for surround sound (MCACC) on page 51 are correct. 1 Select 'Speaker Setting' from the Manual SP Setup menu. 2.Manual SP Setup a.Speaker Setting b.Channel Level c.Speaker Distance 2a.Speaker Setting Front SMALL Center [ SMALL ] Surr [ SMALL ] Surr. Back [ NO ] Subwoofer: YES Return Return 2 Choose the set of speakers that you want to set then select a speaker setting. Use / to select the number of each of the following speakers: • Front - This setting cannot be changed, since it is already optimized for this unit. • Center - Select SMALL if you connect a center speaker. If you didn't connect a center speaker, choose NO (the center channel is sent to the other speakers). • Surr - Select SMALL if you connect surround speakers. If you didn't connect surround speakers choose NO (the sound of the surround channels is sent to the other speakers). • Surr. Back - Select the number of surround back speakers you have (one, two or none).1 If you didn't connect surround back speakers choose NO. • Subwoofer - This setting cannot be changed, since it is already optimized for this unit. 3 When you're finished, press RETURN. You return to the Manual SP Setup menu. Tip For HTP-FS510: If optional speaker systems are not connected, set Center and Surr to NO. For HTP-SB510: If optional speaker systems are not connected, set Surr to NO. Channel Level Using the channel level settings, you can adjust the overall balance of your speaker system, an important factor when setting up a home theater system. Note 1 • If the surround speakers are set to NO, the surround back speakers will automatically be set to NO. • If you select one surround back speaker only, make sure that additional amplifier is hooked up to the PRE OUT SURROUND BACK L (Single) terminal. 73 En