Ricoh 2210L Operating Instructions - Page 179
Labels, any direction.
UPC - 026649304705
View all Ricoh 2210L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 179 highlights
Envelope Margins The following gives typical address margins for a commercial #10 or DL envelope. Type of Address Return address Delivery address Minimum 15 mm (0.6 in.) 51 mm (2 in.) Maximum 51 mm (2 in.) 90 mm (3.5 in.) NOTES: • For the best print quality, position margins no closer than 15 mm (0.6 in.) from the edges of the envelope. • Avoid printing over the area where the envelope's seams meet. Envelope Storage Proper storage of envelopes helps contribute to print quality. Envelopes should be stored flat. If air is trapped in an envelope, creating an air bubble, then the envelope may wrinkle during printing. Labels CAUTION: • To avoid damaging the machine, use only labels recommended for laser printers. • To prevent serious jams, always use the manual feeder to print labels and always use the rear output tray. • Never print on the same sheet of labels more than once and never print on a partial sheet of labels. When selecting labels, consider the quality of each component: • Adhesives: The adhesive material should be stable at 180°C (356°F), the machine's fusing temperature. • Arrangement: Only use labels with no exposed backing between them. Labels can peel off sheets with spaces between the labels, causing serious jams. • Curl: Prior to printing, labels must lie flat with no more than 13mm (5in.) of curl in any direction. • Condition: Do not use labels with wrinkles, bubbles or other indications of separation. A.14