Ricoh ISO1 Operation Manual - Page 19

Connecting To The Host

Get Ricoh ISO1 PDF manuals and user guides View all Ricoh ISO1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

SETTING UP THE SCANNER CONNECTING TO THE HOST Use the following procedure to connect the scanner to a host computer using a SCSI cable. Note the following important points when making SCSI cable connections. Ë Turn all devices being connected before making any connections. Ë The use of cables other than the specified shielded cables or their equivalents will invalidate your scanner's certification and can cause interference levels that exceed the limits established for this equipment. Ë The total length of the SCSI bus should not exceed six meters. Ë Either of the scanner's two SCSI connectors can be used for the connection, but any unused SCSI connector must be capped with a terminator. Note:The RS-232C connector is employed only when the optional Operation Panel is being used. To connect to your host 1 Make sure that the scanner and all the other devices in the SCSI chain are turned off. 1-5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
SETTING UP THE SCANNER
1-5
CONNECTING TO THE HOST
Use the following procedure to connect the scanner to a host computer using a
SCSI cable.
Note the following important points when making SCSI cable connections.
Turn all devices being connected before making any connections.
The use of cables other than the specified shielded cables or their
equivalents will invalidate your scanner’s certification and can cause
interference levels that exceed the limits established for this equipment.
The total length of the SCSI bus should not exceed six meters.
Either of the scanner’s two SCSI connectors can be used for the connection,
but any unused SCSI connector must be capped with a terminator.
Note
:The RS-232C connector is employed
only when the optional
Operation Panel is being used.
To connect to your host
1
Make sure that the scanner and
all the other devices in the SCSI
chain are turned off.