Ricoh ISO1 Operation Manual - Page 26
Dip Switch Settings - scanner driver
View all Ricoh ISO1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
SETTING UP THE SCANNER DIP SWITCH SETTINGS DIP switches on the back of the scanner can be used to control certain scanner features and functions. The following describes the DIP switch settings that can be made by you. Note: You can change the settings of DIP switches 1, 3, and 4 only. Never change the settings of switches 2, 5, 6, 7, or 8. Switch 1 - SCAM Function This switch is used only when there are two units of this scanner model connected in the same SCSI chain, and the computer is equipped with a SCAM adapter. In such a case, Switch 1 of one scanner must be set to ON (SCAM disabled), while Switch 1 of the other scanner must be set to OFF(SCAM enabled). Switch 3 - Paper Size This switch specifies the standard paper sizes the scanner should apply. OFF specifies North American paper sizes, while ON specifies European paper sizes. Switch 4 - IS410 Mode This switch switches between Normal Mode and IS410 Mode. OFF specifies Normal Mode, while ON specifies IS410 Mode. If your application's driver supports the IS410 but not this scanner, you can set this DIP switch to its ON position to enable IS410 emulation. Because of differences between the IS410 and this scanner, however, we cannot guarantee 100% compatibility when IS410 emulation is being used. We recommend that you obtain the appropriate driver from your software dealer. Default settings 1-12