Ricoh ISO1 Operation Manual - Page 22
Setting The Scsi Id
![]() |
View all Ricoh ISO1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
SETTING UP THE SCANNER SETTING THE SCSI ID Each device in a SCSI chain must have its own unique ID. Use the procedure below to set the scanner's SCSI ID. Note the following important points when setting the scanner's SCSI ID. Ë No two devices in the SCSI chain can have the same SCSI ID. Ë You can change the scanner's SCSI ID while power is on, but the new setting does not take effect until you reset the scanner. Ë Never set 8 or 9 as the scanner's SCSI ID. Though 8 and 9 settings are available, you should use IDs 0 through 7 only. To set the scanner's SCSI ID 1 Turn the rotary switch on the back of the scanner until the SCSI ID number you want to use is visible. 2 If the scanner is on when you change the SCSI ID, reset it by turning power off and then back on again. Note: Whenever there are two these scanners connected in the same SCSI chain, be sure to set SW1 of one of the scanner's DIP switches to ON. 1-8
![](/manual_guide/products/ricoh-is450de-operation-manual-dd48caf/22.png)