Ridgid R4510 Operation Manual - Page 42
To Adjust The Bevel Locking Lever, Checking The Table Extension, To Adjust The Table Extension
View all Ridgid R4510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
ADJUSTMENTS TO ADJUST THE BEVEL LOCKING LEVER See Figure 66. Release bevel locking lever and bevel saw blade to 45º. Push bevel locking lever to lock blade into place. With moderate force, attempt to move the bevel adjusting handwheel toward the 0º bevel. If bevel adjusting handwheel cannot be moved, no adjustment is needed. If handwheel can be moved, adjust the bevel lock nut by rotating clockwise 1/4 turn. Repeat above step as necessary. Release bevel locking lever and move bevel adjusting handwheel back to 0º. CHECKING THE TABLE EXTENSION See Figure 67. Lock the sliding table extension. The sliding table extension should not move while locked. If the extension moves: Lift the table extension lock lever. Find the front hex coupling located underneath the front table. Loosen the hex locking nut. Turn the hex coupling counterclockwise. Lock the table extension lock. Push and pull on the sliding table extension. Readjust hex coupling if necessary. Tighten the hex locking nut against coupling. TO ADJUST THE TABLE EXTENSION See Figure 68. Lock table extension lever. Loosen the four nuts underneath the sliding table extension. Use a combination square to make sure the top of the sliding table extension is the same height as the main table. Tighten the four hex nuts. Recheck and readjust if necessary. HEX LOCKING NUT COMBINATION SQUARE BEVEL LOCK NUT FRONT HEX COUPLING Fig. 66 Fig. 67 HEX NUT EXTENSION TABLE Fig. 68 42