Sanyo 24KHS72 Service Manual - Page 36
Maintenance - installation
View all Sanyo 24KHS72 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
7. MAINTENANCE 7-1. Address Setting of the Remote Control Unit The address can be set in order to prevent interference between remote controllers when two indoor units are installed near each other. The address is normally set to "A." To set a different address, it is necessary to change the address on the second remote controller. NOTE Once changed, you cannot restore the original address setting of the air conditioner. (1) Switch on the power source. (2) Break the address-setting tab marked "A" on the second remote controller to change the address (Fig. 13). When the tab is removed, the adress is automatically set to B (Fig. 14). (3) Press and hold the remote controller ION button and 1 HR TIMER button. Then, press and hold the ACL (reset) button with a pointed object such as the tip of a pen. After 5 seconds, release ACL button first, then release ION and 1 HR TIMER buttons, "oP-1" (test run) appears, blinking in the remote controller clock display area. (4) Each time the 1 HR TIMER button is pressed, the display changes as shown below. Press this button 2 times to change the display to "oP-7" (address setting). (Fig. 15) Test run mode Self-diagnostic mode Address setting mode (5) "oP-7" has now been selected for address setting. (6) Press the ON/OFF operation button on the remote controller. (Fig. 15) Check that the "beep" signalreceived sound is heard from the second indoor unit (approximately 5 times). The sound you hear is the signal that the remote controller address has been changed. (7) Finally press the remote controller ACL (reset) button to cancel the blinking "oP-7" display. (Fig. 15) Changing of the second remote controller address is now completed. 36 Tab Fig. 13 Fig. 14 ION button Fig. 15 ACL button ON/OFF operation button 1 HR.TIMER button ACL (Reset) button