Sanyo 24KHS72 Service Manual - Page 94

3-4. Remove the Grille to Install the Indoor Unit Basically, these models can be installed and wired without removing the grille. If access to any internal part is needed, follow the steps as given below. How to remove the grille (1) Grasp both ends of the air intake grille, and remove it by opening towards the front and pulling towards you. (Fig. 16a) (2) Remove the 3 screws. (Fig. 16b) (3) Remove the screw on the right side cover plate and open the cover. (Fig. 17a) (4) Take out the thermistor from the grille. (Fig. 17b) (5) Press the 3 tabs at the top of the grille and the 3 tabs on the front face to separate the grille from the frame. (Fig. 18a) (6) Pull the grill toward you to remove it. How to replace the grille (1) When installing the grille, place the bottom of the grille into the frame first. (Fig. 18b) Then insert the tabs on the top of the grille and on the front face into the frame. (2) Make sure that the grille and frame are firmly fitted together by engaging the tabs. (3) Attach the thermistor on the grille. (Fig. 17a) (4) Close the cover and replace the screw. (Fig. 17a) (5) Affix the grille with the 3 previously removed screws. (Fig. 16b) (6) Install the air intake grille. (a) Allow the edge of the air intake grille to slide into the top of the indoor unit, and then insert it all the way inside. (Fig. 19a) (b) Press the bottom right and left corners and center of the air intake grille to attach it to the indoor unit. (Fig. 19b) NOTE Attach so that the round pins at the top right and left corners of the air intake grille are inserted into the grooves at the top right and left of the indoor unit. Air intake grille Grille Fig. 16a Cover Thermistor Fig. 16b Thermistor Fig. 17a Tab Fig. 17b Tab Fig. 18a Fig. 18b Groove Pin Fig. 19b Fig. 19a 8