Sharp 208D AR-208S AR-208D Operation Manual Suite - Page 285

3 Basic printing PRINTING FROM MACINTOSH (part 2) If the tray runs out of paper during printing Printing will automatically resume when paper is loaded in the tray. When using the bypass tray, select printer mode with the mode select key on the machine, load paper as instructed by the message in the display, and then press the [START] key to resume printing. When the 250-sheet paper feed unit is installed: Note that if the "AUTO TRAY SWITCH" setting in the user programs is enabled and there is the same size of paper in another tray, the machine will automatically switch to the other tray and continue printing. Cancel a print job To cancel a print job that is already in progress, select printer mode with the mode select key on the machine and then press the [CLEAR] key ( ) or the [CLEAR ALL] key ( ). "CANCEL PRINT JOB?" will appear in the display. Select "YES" and press the [ENTER] key. When "Paper Feed" is set to "Auto Select" If "Paper Feed" is set to "Auto Select" in the Print window and the correct size of paper for a print job is not loaded in the machine, the printing procedure will vary depending on the "FORCED OUTPUT" setting in the user programs (see "USER PROGRAMS" in the Operation Manual). When "FORCED OUTPUT" is set to "OFF" Select printer mode with the mode select key on the machine, check the message in the display, load paper in the bypass tray, and then press the [START] key to begin printing. When "FORCED OUTPUT" is set to "ON" Printing takes place on the paper loaded in the machine, even though the paper size is different from the print image size. CONTENTS INDEX 22