Sharp BD-MPC41U BD-MPC41U Operation Manual - Page 36
Preparations and Basic Operations, Before Starting Playback - remote control
UPC - 074000354999
View all Sharp BD-MPC41U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Before Starting Playback Loading the Batteries in the Remote Control 1 Press down on the tab in the direction of the arrow to remove the battery cover. Approximate operating range of remote control Remote control sensor 2 Load the two "AAA" size batteries (R-03 size, UM/SUM-4) supplied with the remote control. Make sure that the battery poles m and n are positioned as indicated. 30º 30º approx. 22 feet (7 m) Remote control 3 Slide the battery cover in the direction of the arrow until it clicks. Connecting the Power Cord Plug the supplied AC cord into the AC IN terminal on the rear of this system. Then plug into an AC outlet with ground hole. To AC IN terminal NOTE • Do not subject the remote control to shock, water or excessive humidity. • The remote control may not function if the system's remote sensor is in direct sunlight or any other strong light. • Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries properly. • Do not mix old and new batteries, or mix different brands. • Remove the batteries if you will not use the remote control for an extended period of time. WARNING • Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries. 34 AC power cord To AC outlet with ground hole NOTE • Place the system close to the AC outlet, and keep the power plug within reach. • TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH THE UN-INSULATED PARTS OF ANY CABLES WHILE THE AC CORD IS CONNECTED. • The STANDBY indicator blinks while the system is preparing for starting up. You cannot turn the system on until the STANDBY indicator stops blinking. • If you are not going to use this system for a long period of time, be sure to remove the AC cord from the AC outlet.