Sharp BD-MPC41U BD-MPC41U Operation Manual - Page 85

Error Messages The following messages appear on the TV screen in case of an error during operation. Error message Cannot play. Incompatible disc. Cannot operate. This USB memory is not formatted properly. Please format the memory in USB memory management. The Connected USB Memory cannot be used. It should be compliant with USB 2.0 Possible Error Suggested Solution • The disc cannot be played back with this system. • Check the disc, and load it correctly. • If you load a disc which cannot be played with this system (i.e. a scratched disc), or if you load a disc upside down, this message will appear, and the disc tray will automatically pop out. • Occurs if the loaded disc cannot be • Remove the disc. played because it is a non-standard disc or scratched, etc. • Occurs if an operation is incorrect. - • Occurs if there is a formatting error. • Occurs if the USB memory is not formatted with FAT 32/16. • Format the USB memory again. • Format the USB memory with your PC. • Occurs if USB memory not compliant • Connect USB 2.0 High Speed with USB 2.0 High Speed (480Mbit/s) is (480Mbit/s) compliant USB memory. used (i.e. USB 1.0/USB 1.1). The following messages are displayed on the main unit, when you fail to perform operations properly. Error Message STANDBY indicator (blinks red) Possible Error • The cooling fan at the rear of the main unit does not run. • Is volume setting very high? • Is system placed in a very hot location? Suggested Solution • Unplug the AC power cord and check if foreign objects get caught around the cooling fan. * • If the system is operated at very high volume levels or in a hot location for an extended period, the protection circuitry may be triggered. Unplug the AC power cord and plug it in again after 5 minutes or more. Then check the operation. * * Should the same message appear even if the system is unplugged and plugged in or is set to the stand-by mode and on again, contact your local dealer where you purchased the system To Reset this System • If this system receives strong interference from a source such as excessive static electricity, strong external noise, malfunction of power supply, or voltage caused by lightning during use or a wrong operation is sent to the system, errors like the system not accepting an operation may occur. • Press and hold POWER (for about 15 seconds) on the main unit. • If the power is on, keep the button pressed down until the front panel display turns off. POWER Front panel STANDBY display When the front panel display is turned off, the reset procedure is complete. indicator • If the power is off, keep the button pressed down until the STANDBY indicator turns off. When the STANDBY indicator is turned off, the reset procedure is complete. Then, after the STANDBY indicator is lit, turn on the power. • When a reset is performed while the power is on, the system will turn off. Turn the power on again. At this point, it may take a few moments for the system processing to finish before the system is ready for use. During the system processing, the BD/DVD/CD mode indicator on the front panel display of the main unit will blink. Once the system processing has finished, the indicator will finish blinking and then light up normally. You can operate the system when the BD/DVD/CD mode indicator is lit. • Since all settings including the language setting stored in memory are also reset when a reset has been performed, they must be set again. • When the problem persists even after performing a reset, unplug the AC cord and plug it in again. If this does not solve the problem, contact the nearest service center approved by SHARP. Appendix 83