Sharp PG-D210U PGD210U Operation Manual - Page 12

Using the Image Invert/Reverse Function This projector is equipped with an image invert/reverse function. The projected image can be inverted or reversed by using the MENU button and the ADJUSTMENT ƒ/∂ and ß/© buttons. On-Screen Display 1 IMAGE ADJ. BLK SCRN DISP INPUT DISPLAY REVERSE INVERT [OFF] [OFF] [OFF] [OFF] :SEL. :ADJ. MENU : E N D 1. Press the MENU button With the MENU screen displayed, press the ADJUSTMENT ƒ/∂ buttons to select "IMAGE ADJ.". Then press the ENTER button to display the "IMAGE ADJ." screen. • The last MENU screen selected is indicated for about 30 seconds. 2 2. Reversed Image Mode INVERT REVERSE INPUT DISPLAY BLK SCRN DISP IMAGE ADJ. In the "IMAGE ADJ." menu, press the [OFF] [ON] [OFF] [OFF] ADJUSTMENT ƒ/∂ buttons to select "REVERSE". Then press the ADJUSTMENT ß/© buttons to select "ON". The reversed image will appear. :ADJ. :SEL. MENU : E N D 3 3. Inverted Image Mode :SEL. :ADJ. MENU : E N D In the "IMAGE ADJ." menu, press the ADJUSTMENT ƒ/∂ buttons to select "INVERT". Then press the ADJUSTMENT ß/© buttons to select "ON". The inverted image will appear. IMAGE ADJ. BLK SCRN DISP INPUT DISPLAY REVERSE INVERT [OFF] [OFF] [OFF] [ON] 4 :ADJ. MENU : E N D :SEL. INVERT REVERSE INPUT DISPLAY BLK SCRN DISP IMAGE ADJ. [ON] [ON] [OFF] [OFF] 4. Reversed Inverted Image Mode In the "IMAGE ADJ." menu, set the "REVERSE" and "INVERT" functions to "ON". The reversed inverted image will appear. 5. Press the MENU button anytime to exit "IMAGE ADJ." How to set up the projector and screen Cautions: When setting up the projector • For minimal servicing and to maintain high image quality, SHARP recommends that this projector be installed in an area free from humidity, dust and cigarette smoke. When the projector is subjected to these environments, the lens and filter must be cleaned more often. Periodically the filter should be replaced and the projector should be cleaned internally. As long as the projector is properly maintained in this manner, use in these environments will not reduce the overall operation life. Please note that all internal cleaning must be performed by an Authorized Sharp Industrial LCD Products Dealer or Service Center. • Do not expose to extreme heat or cold. Operating temperature: 41°F to 104°F (‫ם‬5°C to ‫ם‬40°C) Storage temperature: ‫מ‬4°F to 140°F (‫מ‬20°C to ‫ם‬60°C) • Do not tilt the projector more than 5°. • Position the screen so that it is not in direct sunlight or room light. Light falling directly onto the screen washes out colors, making viewing difficult. Close the curtains and dim the lights when using the screen in a bright or sunny room. • The best picture will be obtained when the projector is at a 90 degree angle to the screen. Position the projector and screen as shown. E-11