Sharp PG-D210U PGD210U Operation Manual - Page 24

6 On-Screen Display For viewing the picture from a video source connected to: VIDEO INPUT 1 VIDEO INPUT 2 COMPUTER RGB1 COMPUTER RGB2 Mac 6. Select input Press the INPUT SELECT button on the projector to switch the picture input. When you press the button, the current input mode is displayed for about 4 seconds. If you press the button again while the input mode is displayed, the mode changes as shown on the left. Confirm the selected input terminal and press the INPUT SELECT button. Notes: • The input can be selected directly using the VIDEO 1, VIDEO 2, DATA 1 and DATA 2 buttons on the remote control. (When DATA 1 or DATA 2 is selected, the RGB 1 or RGB 2 screen will appear accordingly.) • In VIDEO mode, the system being received will be indicated below the "VIDEO" display. • When selecting RGB mode, the resolution being displayed will be indicated under "RGB," as shown on the left. (Refer to the second example when connecting to Mac display.) • When no signals are being received, "NO SIGNAL" will be displayed. When receiving a signal the projector is not preset to receive, "NOT REG." will be displayed. (This display function does not operate in Video mode.) • The picture size differs in RGB, NTSC, PAL and SECAM INPUT modes. 7 7. Press INPUT CHECK When the INPUT CHECK button on the remote con- trol is pressed, the current input mode is displayed for about 4 seconds. Mac Note: • The INPUT CHECK button will not function if the "INPUT DISPLAY" is turned off, as described on page 28. 9 E-23 The number of displayed segments (0-60) increases or decreases as the volume is raised or lowered. VOLUME 38 TURN POWER O F F ? YE S : P R E S S AGAIN NO : P L E A S E WA I T POWER LAMP TEMP. 8. Adjust the volume Press the VOLUME UP-DOWN buttons on the projector or on the remote control to adjust the volume. MUTE • Press the MUTE button to temporarily turn off the sound. • Press the MUTE button once again to turn the sound back on. 9. To turn off the power from the projector or the remote control • Press the POWER ON/OFF button on either the projector or the remote control. The screen on the left will appear. • If you want to turn off the power, press the POWER ON/OFF button on either the projector or the remote control again within 4 seconds. The power is now temporarily turned off. • If you accidentally pressed the POWER ON/OFF button and do not want to turn off the power, wait until the On-Screen Display disappears. The POWER indicator will turn red and the cooling fan will run for 90 seconds, then the power will turn off, and the projector will return to STANDBY mode. The power can be turned on again either from the projector or remote control. When the power is turned on, the POWER indicator and LAMP REPLACEMENT indicator light green. Note: • When the MAIN POWER is off on the projector set, the power cannot be turned on from the remote control.