Sharp PG-D210U PGD210U Operation Manual - Page 33

Installing the lamp unit, Resetting the lamp timer

Get Sharp PG-D210U PDF manuals and user guides View all Sharp PG-D210U manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

Installing the lamp unit 1. Hold the lamp cage (i) by the handle (h) and press it in firmly while making sure that grooves on the side of the lamp cage (j) are properly aligned with the projections inside the lamp cage compartment, and that the holes on the top of the lamp cage (k) are aligned with the screw holes on the projector. 2. Tighten screws (e), (f), (g) and (d), then perform the above instructions in the reverse order. Caution: • Because some parts may not be sufficiently cooled, be sure to remove the lamp cage by the handle while taking care not to touch the metallic areas. Resetting the lamp timer 1 OFF ON 110-120V/ 200-240V~ 1. Plug in the power cord. 2 2. While pressing the ADJUSTMENT ©, ADJUST- OFF ON MENT ƒ, and ENTER buttons on the projector, turn on the MAIN POWER switch. 3 After the projector turns on, "LAMP 0000H" is displayed, indicating that the lamp timer is reset. LAMP 0000H Note: • Only reset the lamp timer after replacing the lamp. E-32

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
E-32
Caution:
•
Because some parts may not be sufficiently cooled, be sure to remove the lamp cage by the handle while taking care not
to touch the metallic areas.
Installing the lamp unit
1.
Hold the lamp cage (i) by the handle (h) and press it in firmly while making sure that grooves on the side of
the lamp cage (j) are properly aligned with the projections inside the lamp cage compartment, and that the
holes on the top of the lamp cage (k) are aligned with the screw holes on the projector.
2.
Tighten screws (e), (f), (g) and (d), then perform the above instructions in the reverse order.
1.
Plug in the power cord.
2.
While pressing the ADJUSTMENT
©
, ADJUST-
MENT
ƒ
, and ENTER buttons on the projector, turn
on the MAIN POWER switch.
After the projector turns on, “LAMP 0000H” is displayed,
indicating that the lamp timer is reset.
Note:
•
Only reset the lamp timer after replacing the lamp.
Resetting the lamp timer
1
OFF
ON
110-120V/
200-240V~
2
3
ON
OFF
LAMP
0000
H