Sharp PG-D210U PGD210U Operation Manual - Page 22

Basic Operation of the Projector 1 OFF ON 110-120V/ 200-240V~ 1 AC cord 1. Connect the AC cord Connect the supplied AC cord to the AC inlet on the back of the projector. 2 OFF ON POWER LAMP TEMP. When the MAIN POWER is on, the POWER indicator lights red. 2. Turn on the MAIN POWER Press the MAIN POWER switch on the back of the projector. The POWER indicator lights red and the projector enters STANDBY mode. 3 Projector Remote control ON/OFF ON/OFF ON OFF POWER LAMP TEMP. When the power is on, the LAMP REPLACEMENT indicator flashes to show the operating condition of the lamp. Green: Lamp is ready Flashing green: Warming up Red: Change bulb 3. Turn on the POWER Press the POWER ON/OFF button on the projector or the POWER ON button on the remote control. • When the power is turned off by pressing the POWER ON/OFF button, the POWER indicator will not turn off until the fan has stopped running. • See page 30, "Lamp/Maintenance Indicators" for details. Notes: • When the POWER indicator is not lit, the remote control cannot be used to operate the projector. • The flashing green LAMP REPLACEMENT indicator indicates that the lamp is warming up. Wait until the indicator stops flashing before operating the projector. • If the power is turned on immediately after it has been turned off, it may take a short while before the lamp turns on. (During this period the LAMP REPLACEMENT indicator flashes.) • After the projector is unpacked and turned on for the first time, a slight odor may be emitted from the exhaust fan. This odor will soon disappear with use. Caution: • Be sure to take off the lens cap before operation of the projector. Do not place the lens cap on the lens during operation. The lens cap may become extremely hot. E-21