Sharp PG-D210U PGD210U Operation Manual - Page 17
Connecting to the Computer RGB Input RGB 1, 2/Output Terminals - resolution
View all Sharp PG-D210U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Connecting to the Computer RGB Input (RGB 1, 2)/Output Terminals You can connect your projector to a computer for easy projection of full-color computer images, and an external monitor for simultaneous viewing. 1 Rear view of the projector IN 1 COMPUTER RGB IN 2 RGB Signal Input Socket 1. Connecting to an IBM-PC (VGA, SVGA, XGA, SXGA) Series computer-1,280 1,024 maximum resolution Plug one end of the RGB signal cable into the RGB INPUT terminal on the projector and the other end into the RGB signal output terminal on the computer, and secure the plugs by tightening the thumb screws. RGB Signal Cable (Supplied) ANALOG RGB OUT IBM-PC (VGA, SVGA, XGA, SXGA) Series (computer) RGB Signal Output Socket Notes: • This connection is possible only when using a computer with a VGA/ SVGA/XGA/SXGA or Mac display output port. • By using RGB INPUT 2 and PC CONTROL 2, another computer can be connected to and operated with the projector. 2 ! Macintosh Adaptor (Supplied) ON ↑ ↓ OFF @ Macintosh Macintosh Adaptor (Supplied) ANALOG RGB OUT RGB Signal Output Socket 2. Connecting to a Macintosh Series Computer 640 480, 832 624 or 1,024 768 resolution ! Set the proper switches on the supplied adaptor. • For 640 ן480 resolution, set switches 1 and 2 to "ON" and 3, 4, 5 and 6 to "OFF". • For 832 ן624 resolution, set switches 2 and 4 to "ON" and 1, 3, 5 and 6 to "OFF". • For 1,024 ן768 resolution, set switches 2 and 3 to "ON" and 1, 4, 5 and 6 to "OFF". @ Connect the supplied Macintosh adaptor to the RGB signal output terminal on your Macintosh Series computer, as shown on the left, and secure the plugs by tightening the thumb screws. # Rear view of the projector IN 1 COMPUTER RGB IN 2 # Firmly plug one end of the supplied RGB signal cable into the RGB input terminal on the projector and the other end to the Macintosh adaptor on the computer, and secure the plugs by tightening the thumb screws. RGB Signal Input Socket Macintosh RGB Signal Output Socket ANALOG RGB OUT RGB Signal Cable (Supplied) Notes: • Be sure to use the supplied Macintosh adaptor. • Be sure the switches on the adaptor are properly set. • Once the adaptor is connected to a computer and the computer is turned on, the display mode cannot be changed even if the switches on the adaptor are reset. • The supplied adaptor is only for use with H-SYNC and V-SYNC output. When connecting a Macintosh Series computer that only outputs C-SYNC, use a special C-SYNC output adaptor (sold separately). E-16