Sharp PN-L702B PN-L702B Professional LCD Monitor Operation Manual - Page 25

Menu Items USER Adjusts each item when the WHITE BALANCE is set to USER. R-CONTRAST.....Adjusts bright-toned red component. G-CONTRAST....Adjusts bright-toned green component. B-CONTRAST.....Adjusts bright-toned blue component. R-OFFSET..........Adjusts dark-toned red component. G-OFFSET..........Adjusts dark-toned green component. B-OFFSET..........Adjusts dark-toned blue component. COPY TO USER Copies the value of white set for PRESET to the USER setting. Select "ON" and then press MENU . (In the case other than white, color tone may differ from the PRESET.) GAMMA Selects the gamma. USER sets the gamma to the sent value (see page 35). (In PIP mode, the main side setting is reflected in the image.) DISPLAY COLOR PATTERN Displays a color pattern. Can be displayed while the menu screen is displayed, so you can refer to the pattern while adjusting the image. OFF No pattern display. WHITE........... White single color pattern display. RED Red single color pattern display. GREEN......... Green single color pattern display. BLUE Blue single color pattern display. USER Red/green/blue mixed color pattern display. When USER is selected, set each color's level. RESET Resets the values of the PICTURE menu items to the factory preset values. Select "ON" and then press MENU . nAUDIO TREBLE Adjusts the volume of treble-level sound. BASS Adjusts the volume of bass-level sound. BALANCE Adjusts the balance of the audio sound between right and left. RESET Resets the values of the AUDIO menu items to the factory preset values. Select "ON" and then press MENU . nSETUP OSD H-POSITION Adjusts the horizontal display position of menu screen. OSD V-POSITION Adjusts the vertical display position of menu screen. SCREEN MOTION Residual images are reduced by moving the screen. PATTERN1..........The whole screen moves vertically and horizontally. PATTERN2..........A black screen spreads from the bottom of the screen and then shrinks to the bottom of the screen. PATTERN3..........A black bar moves from the left end to the right end of the screen. PATTERN4..........Black screens appear from both the top and bottom of the screen, and the displayed image is compressed into the central field. PATTERN1 PATTERN2 PATTERN3 PATTERN4 MOTION TIME 1 Specify a time period (operating interval) until SCREEN MOTION starts. MOTION TIME 2 Specify a time period during which SCREEN MOTION operates (time period during which the screen will move). MONAURAL AUDIO Outputs audio signals as monaural. LANGUAGE Sets the display language for the menu screen. POWER ON DELAY You can delay the screen display after the monitor is turned on. The period can be set up to 60 seconds in units of one second. When this function is activated, the power LED flashes (at approx. 1 second interval) in orange. This function is disabled when 0 is specified. STANDBY MODE When STANDARD is selected, startup time from standby mode is reduced. Note, however that, more power will be consumed in standby mode. When LOW POWER is selected, current consumption is reduced while the monitor is in standby mode. Note, however, that the startup time from standby mode becomes longer. If set to LOW POWER, certain RS-232C commands cannot be used in standby mode, and control via LAN will be disabled. OFF IF NO OPERATION Determines whether or not to set the monitor to go into standby mode when there is no operation from the remote control unit, RS-232C commands, or LAN for over 4 hours. 25 E