Sharp UP-700 Instruction Manual - Page 130

Direct Key Programming Use the following procedure to select direct-key programming: s Direct key You can assign departments and PLUs directly to the keyboard. In the case of PLUs, you may assign up to 3 levels to be accessed directly on the keyboard. For key no. positions, refer to the illustration shown below. Procedure w Select a pertinent key no. from the key numbers list. w w In the case of selecting "061 DIRECT PLU" • TYPE (Use the selective entry) PLU: Assigns the key as a direct PLU key. DEPT: Assigns the key as a direct department key. NOTE • You can also select a direct PLU key by pressing the corresponding key when the PLU has been assigned directly on the keyboard instead of selecting the key from the menu. • When selecting a department, the screen on which a department code is to be entered (the message "DEPT. CODE") will appear. • LEVEL1 through 3 (Use the numeric entry) Enter a PLU code for each level. For example, if you want to use this key as PLU code 1 (level 1) and PLU code 101 (level 2), enter 1 for "LEVEL1" and 101 for "LEVEL2." Key numbers 25 RECEIPT JOURNAL 34 43 52 61 70 79 88 97 106 115 124 133 142 8 16 24 33 42 51 60 69 78 87 96 105 114 123 132 141 7 15 23 32 41 50 59 68 77 86 95 104 113 122 131 140 6 14 22 31 40 49 58 67 76 85 94 103 112 121 130 139 5 13 21 30 39 48 57 66 75 84 93 102 111 120 129 138 4 12 20 29 38 47 56 65 74 83 92 101 110 119 128 137 3 11 19 28 37 46 55 64 73 82 91 100 109 118 127 136 2 10 18 27 36 45 54 63 72 81 90 99 108 117 126 135 1 9 17 26 35 44 53 62 71 80 89 98 107 116 125 134 Departments and PLUs programmable area NOTE • You can assign departments and PLUs only the "Departments and PLUs programmable area" shown above. • You cannot assign a department or a PLU to the position to which a function key has been assigned. 128