Sharp XL-DV60 XL-DV60 Operation Manual - Page 54

References XL-DV60 Maintenance " Cleaning the laser pickup lens In order to ensure proper operation of the DVD player, preventative maintenance (cleaning of the laser pickup lens) should be performed periodically. Lens cleaners are commercially available. Contact your local DVD software dealer for options. " Cleaning the cabinet Periodically wipe the cabinet with a soft cloth and a diluted soap solution, then with a dry cloth. Caution: ! Do not use chemicals for cleaning (gasoline, paint thinner, etc.). It may damage the cabinet finish. ! Do not apply oil to the inside of unit as this may cause malfunc- tions. " Care of discs Discs are fairly resistant to damage, however mistracking can occur due to an accumulation of dirt on the disc surface. Follow the guide- lines below for maximum enjoyment from your disc collection and player. ! Do not write on either side of the disc, particularly the non-label side from which signals are read. Do not mark this surface. ! Keep your discs away from direct sunlight, heat, and excessive moisture. ! Always hold the discs by the edges. Fingerprints, dirt, or water on the discs can cause noise or mistracking. If a disc is dirty or does not play properly, clean it with a soft, dry cloth, wiping straight out from the center, along the radius. NO YES Correct Specifications As part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units. " General Power source AC 120 V, 60 Hz Power consumption 116 W Dimensions Width: 6-5/16" (160 mm) Height: 9-7/16" (240 mm) Depth: 12-9/16" (319 mm) Weight 12.3 lbs. (5.6 kg) " Amplifier Output power Audio output terminals Audio input terminals Video output terminals Front speakers: 37.5 watts minimum RMS per channel into 6 ohms from 100 Hz to 20 kHz, 10% total harmonic distortion Subwoofer: 45 watts minimum RMS into 6 ohms from 70 Hz to 130 Hz, 10% total harmonic distortion Front speakers and subwoofer: 6 ohms Headphones: 16 - 50 ohms (recommended: 32 ohms) Optical digital output: Square type 1 Video/Auxiliary (audio signal): 500 mV/47 k ohms Video output: RCA type 1 S-video output: S-terminal 1 Component video output: RCA type 3 (Pr/Cr, Pb/Cb, Y) 54