Sony HDCU-4300 Operation Guide - Page 35

Menu List Note The following conventions are used in the menu list table. Settings column values (e.g. ON, OFF, 0): Default settings are underlined Execute using ENTER: Press the CONTROL knob or move the CANCEL/ENTER lever to the ENTER position to execute. SYSTEM OPERATION menu SYSTEM OPERATION Page name Page No. S01 S02 Item Set value Indication OUTPUT LASER DIODE START UP VIDEO SIGNAL REFERENCE LOCK STATUS GENLOCK 10F BB H-PHASE STEP H-PHASE COARSE V-PHASE SYNC OUT SELECT CAMERA, BAR, TEST1, TEST2 Selects the output signal. TEST1 and TEST2 are not selectable if there is no communication with the camera. ON, OFF Turns the optical signal output from the CCU to the camera ON/OFF. (Displayed only when connected using optical fiber composite cable.) BARS, GRAY Selects the signal to output until the unit connects with the camera after power-on. (NOT DETECTED), (1080/59.94I), (1080/23.98PsF), (720/59.94P), (1080/50I), (1080/24PsF), (720/ 50P), (UNKNOWN) Signal input of the Reference connector (Display only) (LOCKED), (NOT LOCKED) Lock status of the external reference signal (Display only). HD, SD, NETWORK Selects the lock mode of the external reference signal. (NETWORK is displayed when HKCU-4001 is installed.) OFF, ON Sets whether to use the 10Field ID added to the external reference signal This can be selected when GENLOCK is SD and page t SYSTEM is 1.001(525). When HD is selected in GENLOCK: -3.01 to +3.45 µsec 0.00 Adjusts the horizontal lock phase in relation to the reference signal (steps) When SD is selected in GENLOCK: -8.29 to +9.48 µsec 0.00 -99 to 99 0 Adjusts the horizontal lock phase in relation to the reference signal (fine adjustment) 0 to 7 Adjusts the vertical lock phase in relation to the reference signal (lines) SD SYNC, HD SYNC Sets the output signal of the CHARACTER/SYNC OUT connector This is enabled only when MAINTENANCE Menu t page t CHARACTER/SYNC is SYNC. 35