Sony HDCU-4300 Operation Guide - Page 40
SIMPLE HD, ZOOM&PERSPECTIVE, LINE14, LINE577, name, No., Set value, Indication
View all Sony HDCU-4300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
SYSTEM OPERATION Page name Page No. S08 S10 (When HKCU-IP43F or HKCU-4001 is installed) Item HD CUTOUT MODE CUTOUT CH CENTER H CENTER V ZOOM CAMERA TILT CAMERA ROLL FOCAL LENGTH S09 S11 (When HKCU-IP43F or HKCU-4001 is installed) META 1st F 2nd F Set value OFF, ON SIMPLE HD, ZOOM&PERSPECTIVE 1, 2 -1536 to 1535, 0 -810 to 809, 0 1.0 to 4.0, 2.0 -45.0 to 45.0, 0 -5.0 to 5.0, 0 7 to 500, ∞ OFF, ON LINE9 to LINE20, LINE14 LINE572 to LINE583, LINE577 Indication Turns the HD cutout function ON/OFF. Enabled only when HDC(HD CUTOUT) is selected in CHU MODE. The cutout HD signal from the 4K source is output from SLOT1. Selects the cutout mode. SIMPLE HD: Outputs a 1920x1080 HD region cutout from the 4K video as-is. Dual output is supported. The cutout signal set by the CUTOUT POSITION CH1 setting is output from the 1/2 connector and 5/6 connector of Slot1, and the cutout signal set by the CUTOUT POSITION CH2 setting is output from the 3/4 connector and 7/8 connector of Slot1. ZOOM&PERSPECTIVE: Outputs an HD signal formed by zooming in or out of the cutout region from the 4K video. In this mode, a perspective transformation is performed according to the focal length of the lens, and an image similar to the image obtained by the camera facing the cutout direction is output. Selects the cutout position channel. Only channel 1 is available when ZOOM&PERSPECTIVE is selected. Specifies the cutout position center (horizontal direction, 0: center). (Setting when MODE is ZOOM&PERSPECTIVE, CUTOUT POSITION ZOOM is 4.0, and FOCAL LENGTH is Infinity) Specifies the cutout position center (vertical direction, 0: center). (Setting when MODE is ZOOM&PERSPECTIVE, CUTOUT POSITION ZOOM is 4.0, and FOCAL LENGTH is Infinity) Specifies the zoom factor (1.0: same position as the 4K video) Enabled only when ZOOM&PERSPECTIVE is selected. Specifies the tilt angle of the camera (0: horizontal, positive angles represent upward tilt) Enabled only when ZOOM&PERSPECTIVE is selected. Specifies the roll angle of the camera (0: horizontal, positive values represent counterclockwise roll) Enabled only when ZOOM&PERSPECTIVE is selected. Specifies the focal length of the lens (unit: mm) To avoid shape change due to perspective transformation, increase the focal length until "INFINITY" is displayed. Enabled only when ZOOM&PERSPECTIVE is selected. SR Live metadata embed on/off setting Line number used in 1st field Line number used in 2nd field 40