Sony HDR FX7 Operating Instructions - Page 62
Shot Trans, Dv Frame Rec, Back Light, Trans Time, Trans Curve, Linear, Soft Stop
UPC - 027242701946
View all Sony HDR FX7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Press the MENU button t select the (CAMERA SET) by turning the SEL/PUSH EXEC dial. SHOT TRANS Select this setting to set the transition time and curve. See page 45 for details on using the shot transition function. x TRANS TIME Select transition time ([3.5 sec] to [15.0 sec] seconds, the default setting is [4 sec]). x TRANS CURVE Select the transition curve. The transition curve changes as follows. *1: parameter level *2: transition of time LINEAR Make the transition linearly. *1 *2 B SOFT STOP Make the transition slowly at the end. *1 *2 SOFT TRANS Make the transition slowly at the beginning and end, and linearly in between. *1 *2 b Note • You cannot change [TRANS TIME] and [TRANS CURVE] settings during store, check, or execution of [SHOT TRANS]. Cancel [SHOT TRANS] setting by pressing the ASSIGN button 1 several times before changing [TRANS TIME] or [TRANS CURVE] setting. DV FRAME REC You can record pictures with a stop-motion animated effect by alternately recording a few frames and then moving the subject a little. Operate your camcorder using the Remote Commander to prevent camera shake. B OFF Select to record in the standard recording mode. ON ( ) Select to record pictures using the DV FRAME REC function. 1 Select [ON] by the SEL/PUSH EXEC dial. 2 Press the MENU button to hide the menu screen. 3 Press the REC START/STOP button. A picture (approximately 6 frames) is recorded, and your camcorder enters the standby mode. 4 Move the subject and repeat step 3. b Note • When you use frame recording continuously, the remaining tape time will not be indicated correctly. • The last scene will be longer than other scenes. • You cannot record index signals during frame recording. • This is automatically set to [OFF] if you turn the power off and back on. BACK LIGHT When you set [BACK LIGHT] to [ON], . is displayed and the back light function is enabled (the default setting is [OFF]). b Notes • The back light function is canceled when you set [SPOTLIGHT] to [ON]. 62