Sony HXRNX80 Operating Instructions - Page 161
Casing, Care and storage of the lens, Charging the pre-installed, rechargeable battery
View all Sony HXRNX80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
x To clean the LCD screen The LCD screen is covered with a coating. The coating may be peeled off by scratching or rubbing. Maintain the LCD screen as follows. • Wipe fingerprints or hand cream off the LCD screen as soon as possible, as they may cause the coating to peel off. • If you rub the LCD screen hard, even with a tissue, the coating may be damaged. • Before wiping the LCD screen, blow dust or sand off with a dust blower, etc. • Wipe dirt off the LCD screen with a clean, soft cloth, such as an eye glass cleaning cloth, etc. x To adjust the touch panel (CALIBRATION) The buttons on the touch panel may not work correctly. If this happens, follow the procedure below. It is recommended that you connect your camcorder to the wall outlet (wall socket) using the supplied AC Adaptor during the operation. 1 Press the MENU button t select (OTHERS) t [CALIBRATION] with the v/V/b/B/SET button. 2 Touch "×" displayed on the LCD screen with the corner of memory card or the like 3 times. b Notes • If you did not press the right spot, try the calibration again. • Do not use a sharp-pointed object for calibration. Doing so may damage the LCD screen. • You cannot perform the calibration when the LCD screen is turned around, or facing up and closed to the camcorder x OLED panel display The OLED panel may experience issues such as screen burn-in or loss of brightness with normal use over time. This is not a malfunction. Casing • If the casing is soiled, clean the camcorder body with a soft cloth lightly moistened with water, and then wipe the casing with a dry soft cloth. • Avoid the following to prevent damage to the finish. - Using chemicals such as thinner, benzine, alcohol, chemical cloths, repellent, insecticide and sunscreen. - Handling with above substances on your hands. - Leaving the casing in contact with rubber or vinyl objects for a long period of time. Care and storage of the lens • Wipe the surface of the lens clean with a soft cloth in the following instances: when there are fingerprints on the lens surface, in hot or humid locations, and when the lens is exposed to salty air such as at the seaside. • Store in a well-ventilated location subject to little dirt or dust. • To prevent mold, periodically clean the lens as described above. Charging the pre-installed rechargeable battery Your camcorder has a pre-installed rechargeable battery to retain the date, time, and other settings even when the 1 (On/ Standby) button is set to the standby position. The pre-installed rechargeable battery is always charged while your camcorder is connected to the wall outlet (wall socket) via the AC Adaptor or while the battery pack is attached. The rechargeable battery will be fully discharged in about 3 months if you do not use your camcorder at all, with the AC Adaptor not connected or battery pack not attached. Use your camcorder after charging the pre-installed rechargeable battery. However, even if the pre-installed rechargeable battery is not charged, the camcorder operation will not be affected as long as you are not recording the date. Continued , 161 Additional Information