Symantec 10521146 User Guide - Page 18

18 Setup overview Figure 1-6 Bypass unit rear panel LEDs Table 1-4 describes the LEDs shown in the diagram. Table 1-4 Bypass unit rear panel LED descriptions LED label LED name LED color LT Link test Green ALM Alarm Red BYP Bypass Yellow ON Online Green GIG Gigabit Green Description The LT LED glows green to indicate an active link signal on the port. The ALM LED in the top right corner of the Net A port glows red for an alarm condition such as lack of a link signal on one or more ports in the port group. The BYP LED in the top right corner of the App A port glows yellow when the port group is operating in bypass mode. The ON LED in the top right corner of the App B port glows green when the port group is operating in online mode. The GIG LED in the top right corner of the Net B port glows green when the port group is operating in gigabit mode (1000Mbps). It is off when the port group is operating at 100 Mbps or 10 Mbps. Setup overview You can set up the In-line Bypass unit in five basic steps. To set up the In-line Bypass unit 1 Mount the bypass unit onto the rack. See "Mounting onto a rack" on page 19.