Symantec 10521146 User Guide - Page 19

Mounting onto a rack

Get Symantec 10521146 - Network Security 7120 PDF manuals and user guides
UPC - 037648268134
View all Symantec 10521146 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

19 Mounting onto a rack 2 Cable the bypass unit to one or more in-line interface pairs on the 7100 Series appliance. See "Cabling the 2 In-line Bypass unit to the 7120" on page 20. See "Cabling the 4 In-line Bypass unit to the 7160" on page 23. 3 Connect the power and turn on the bypass unit. See "Connecting the power on the 2 In-line Bypass unit" on page 22. See "Connecting the power on the 4 In-line Bypass unit" on page 26. 4 Boot up the 7100 Series appliance. 5 Start a sensor on each appliance in-line pair that is connected to the bypass unit. See the Symantec Network Security 7100 Series Implementation Guide. Mounting onto a rack The bypass unit rack mounting hardware includes two L-brackets. The In-line Bypass unit includes four screws that are threaded into the cover sides. You can use these screws to attach the L-brackets to the bypass unit. To mount using L-brackets onto a two-post rack 1 Remove the four screws from the bypass unit cover. Position each L-bracket against the bypass unit side panel toward the rear, as shown. Attach the brackets securely using the same screws. 2 Lift the bypass unit into place so that the L-brackets press against the rack posts.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
19
Mounting onto a rack
2
Cable the bypass unit to one or more in-line interface pairs on the 7100
Series appliance.
See
“Cabling the 2 In-line Bypass unit to the 7120”
on page 20.
See
“Cabling the 4 In-line Bypass unit to the 7160”
on page 23.
3
Connect the power and turn on the bypass unit.
See
“Connecting the power on the 2 In-line Bypass unit”
on page 22.
See
“Connecting the power on the 4 In-line Bypass unit”
on page 26.
4
Boot up the 7100 Series appliance.
5
Start a sensor on each appliance in-line pair that is connected to the bypass
unit.
See the
Symantec Network Security 7100 Series Implementation Guide
.
Mounting onto a rack
The bypass unit rack mounting hardware includes two L-brackets. The In-line
Bypass unit includes four screws that are threaded into the cover sides. You can
use these screws to attach the L-brackets to the bypass unit.
To mount using L-brackets onto a two-post rack
1
Remove the four screws from the bypass unit cover. Position each L-bracket
against the bypass unit side panel toward the rear, as shown. Attach the
brackets securely using the same screws.
2
Lift the bypass unit into place so that the L-brackets press against the rack
posts.