Symphonic RSMGTD204 Owner's Manual - Page 18
Channel Set Up, Deleting Or Adding, Channels
![]() |
View all Symphonic RSMGTD204 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
CHANNEL SET UP TV/VCR You can program the tuner to scan all the channels you receive in your area. NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just select the TV/VCR/DVD channel selector to the output channel of the cable box or satellite box (Ex CH3), then select the channel to be viewed on the Cable Box or Satellite Box. Make sure ... • Press the POWER button to turn on the TV/VCR/DVD. DELETING (OR ADDING) CHANNEL(S) TV/VCR The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add the deleted channel into the memory again.) 1 Select "CHANNEL SET UP" Press the SETUP button on the remote control. Press the Arrow button K or L to point to "CHANNEL SET UP". Then press the ENTER button. - TV/VCR SETUP - TIMER PROGRAMMING SETTING CLOCK B CHANNEL SET UP USER'S SET UP V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF] ZERO RETURN TIME SEARCH INDEX SEARCH 1 Select "CHANNEL SET UP" Press the SETUP button on the remote control. Press the Arrow button K or L to point to "CHANNEL SET UP". Then press the ENTER button. - TV/VCR SETUP - TIMER PROGRAMMING SETTING CLOCK B CHANNEL SET UP USER'S SET UP V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF] ZERO RETURN TIME SEARCH INDEX SEARCH 2 Begin auto ch programming Press the Arrow button K or L to point to "AUTO CH PROGRAMMING". Then press the ENTER button. The tuner scans and memorizes all the active channels in your area. - CHANNEL SET UP - ADD / DELETE CH (CATV) B AUTO CH PROGRAMMING 3 After scanning The tuner stops on the lowest memorized channel. • When AUTO CH PROGRAMMING is activated where there is no TV signal input, "NO TV SIGNALS" will appear on the display after the completion of the channel scanning. • The TV/VCR/DVD may recognize TV channels to be CATV channels by the receiving conditions. In this case, try auto ch programming again in the fine receiving conditions. 2 Select "ADD/DELETE CH" Press the Arrow button K or L to point to "ADD/DELETE CH". Press the ENTER button. - CHANNEL SET UP - B ADD / DELETE CH (CATV) AUTO CH PROGRAMMING 3 Enter the desired channel number Press the Arrow button K or L until your desired channel number appears. (You can also use the 08 number buttons or the CHANNEL button K or L to enter it.) ADD / DELETE • You must precede single-digit (Example: CH8) channel numbers with a zero (Example: 02 ... 09). • When selecting cable channels which are higher than 99, press the +100 button first then press the last two digits. (Example: to select channel 125, first press the +100 button then press "2" and "5"). 4 Delete (or add) it from (or into) memory Press the ENTER button. The channel number changes to light red. The channel is deleted from memory. • To delete another channel, repeat steps [3] to [4]. • If you press the ENTER button again, the channel is memorized again. Added channel: Light blue. Deleted channel: Light red. 5 Exit the channel setup mode Press the SETUP button on the remote control to return to TV mode. NOTE: To confirm that channel(s) has been deleted or added, press the CHANNEL button K or L. - 18 - EN 1C29
![](/manual_guide/products/symphonic-rsmgtd204-owners-manual-acdea0b/18.png)