TEAC CD-9010 SYSTEM Owners Manual - Page 18

4 - Playback Playing a track once from the beginning Follow these steps to select and check the desired track (monitoring playback), and then play it through the main outputs (online playback). These procedures assume that all menu items are at their default settings. 1. Press the PLAY MODE button to select single mode. •• Press the PLAY MODE button as many times as necessary until the SINGLE playback mode indicator appears on the Home Screen. 2. Press the MENU button to open the MENU screen, and set AUTO CUE in the PLAY menu to ON. 3. Press the HOME button to open the Home Screen. 4. Use the TRACK .// buttons to select a track for playback. •• The unit enters playback standby at the position where an audio signal is detected in the selected track (and the STANDBY button lights). NOTE When the playback mode is set to CONTINUE or SINGLE, you can use the number buttons (0 through 9) to select tracks. Enter two digits for audio CDs or three digits for data CDs. (For example, press the 0 button followed by the 2 button to select track 2 on an audio CD.) 5. To check the playback signal, press the MONITOR button to start monitoring playback (the MONITOR button lights). •• In addition to using an external monitoring system, you can also monitor the playback signal using headphones connected to the unit's PHONES jack. 6. After checking the signal, press the STANDBY button. •• The playback position is set to the point where the track starts and the unit enters playback standby mode (the STANDBY button lights). 7. Press the PLAY button to start online playback. •• When the track ends, the unit re-enters playback standby. •• Press the STOP button to stop playback immediately. Playing a track from the middle Follow these steps to find a point in the middle of a track and start playback from the main outputs from that point. 1. When stopped or during playback standby, you can search within a track using the SEARCH m/, buttons to locate a desired point and put the unit in playback standby there. (See "Searching within tracks" on page 19.) 2. At the desired playback point, press the MONITOR button to start monitoring playback and check it. 3. After checking, press the STANDBY button to return to the point set earlier and start online playback standby (STANDBY button lights). •• To adjust the set point, return to step 1. 4. Press the PLAY button to start online playback. When the track ends, the unit will enter playback standby mode. NOTE Press the STOP button to stop playback immediately. Automatic cue point memory (last cue) When you start monitoring playback from a stopped or playback standby state, the starting position is automatically memorized as a cue point. The most recently added cue point is the "last cue point". Press the STANDBY button to locate to the last cue point (where monitoring playback last started) and enter playback standby. NOTE •• When using a TASCAM RC-9010/RC-9010S remote control (sold separately), you can assign automatic cue points to the number (0-9) buttons. •• In jog mode, pressing the STANDBY button saves the current position as a cue point. 18 TASCAM CD-9010