TEAC CD-9010 SYSTEM Owners Manual - Page 29
– Other settings and information display, Setting the digital reference level, Setting the analog
View all TEAC CD-9010 SYSTEM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
7 - Other settings and information display Setting the digital reference level You can set the digital headroom (number of dB below maximum analog output reference level (full scale). 1. Press the MENU button to open the MENU screen. 2. Open the SYSTEM menu. 3. Select DIGITAL REF LVL. Adjusting R/L analog reference levels You can adjust the analog output reference level separately for the left and right channels. 1. Press the MENU button to open the MENU screen. 2. Open the SYSTEM menu 3. Select ANALOG REF ADJ L or ANALOG REF ADJ R. 4. Press the DATA dial to move the cursor right to select the setting. 5. Turn the DATA dial to set the digital reference level. •• Options: -20dBFS, -18dBFS (default value), -16dBFS, -14dBFS, -9dBFS 6. After completing the setting, press the HOME button to return to the Home Screen. NOTE •• The digital reference level setting is retained even when the power is turned OFF. •• This setting only applies to the line outputs. Setting the analog reference level You can set the analog output reference level. The analog audio output reference level settings that are possible depend on the digital reference level setting. 1. Press the MENU button to open the MENU screen. 2. Open the SYSTEM menu. 3. Select ANALOG REF LVL. 4. Press the DATA dial to move the cursor right to select the setting. 5. Turn the DATA dial to adjust the analog reference level. •• Setting range: ±6.0 dB (default value: 0dB, 0.1dB increments) 6. After completing the setting, press the HOME button to return to the Home Screen. NOTE •• The analog reference level settings are retained even when the power is turned OFF. •• This setting only applies to the line outputs. Setting the online function You can set whether or not to use the online function. 1. Press the MENU button to open the MENU screen. 2. Open the SYSTEM menu. 3. Select ONLINE FUNCTION. 4. Press the DATA dial to move the cursor right to select the setting. 5. Turn the DATA dial to set the analog reference level. The analog reference setting value options depend on the DIGITAL REF LVL setting. DIGITAL REF LVL setting -9dBFS Settings other than -9dBFS ANALOG REF LVL setting +6dBu only -20dBu, +4dBu (default value) 6. After completing the setting, press the HOME button to return to the Home Screen. NOTE •• This setting only applies to the line outputs. •• This analog reference level setting is retained even when the power is turned OFF. 3. Press the DATA dial to move the cursor right to select the setting. 4. Turn the DATA dial to set the online function. •• SWTCH.OK (default value): Online playback mode can be controlled through the parallel remote connector, the serial remote connector, and by a TASCAM RC-9010/ RC-9010S remote controller (sold separately). When this unit is used alone, online playback mode is ON by default. •• AlwaysON: Online playback mode is always ON and cannot be switched. 6. After completing the setting, press the HOME button to return to the Home Screen. NOTE The online function setting is retained even when the power is turned OFF. TASCAM CD-9010 29