TP-Link TD-VG3511 TD-VG3511 V1 User Guide - Page 44
TD-VG3511, IP Address, Subnet Mask, Enable Second IP, DHCP Server, Start IP Address
View all TP-Link TD-VG3511 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
TD-VG3511 150Mbps Wireless N VoIP ADSL2+ Modem Router User Guide Figure 4-15 ¾ IP Address: You can configure the Modem Router's IP Address and Subnet Mask for LAN Interface. • IP Address: Enter the Modem Router's local IP Address, then you can access to the Web-based Utility via the IP Address, the default value is 192.168.1.1. • Subnet Mask: Enter the Modem Router's Subnet Mask, the default value is 255.255.255.0. ¾ Enable Second IP: You can configure the Modem Router's second IP Address and Subnet Mask for LAN Interface through which you can also access to the Web-based Utility as the default IP Address and Subnet Mask. ¾ DHCP Server: These settings allow you to configure the Modem Router's Dynamic Host Configuration Protocol (DHCP) server function. The DHCP server is enabled by default for the Modem Router's Ethernet LAN interface. DHCP service will supply IP settings to computers which are configured to automatically obtain IP settings that are connected to the Modem Router though the Ethernet port. When the Modem Router is set for DHCP, it becomes the default gateway for DHCP client connected to it. Keep in mind that if you change the IP address of the Modem Router, you must change the range of IP addresses in the pool used for DHCP on the LAN. • Start IP Address: Enter a value for the DHCP server to start with when issuing IP addresses. Because the default IP address for the Modem Router is 192.168.1.1, the default Start IP Address is 192.168.1.100, and the Start IP Address must be 192.168.1.2 or greater, but smaller than 192.168.1.254. 35