TP-Link TL-R480T User Guide - Page 9
The Rear Panel, 2.2 System Requirements, 2.3 Installation Environment Requirements - reboot
UPC - 696726480020
View all TP-Link TL-R480T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
TL-R480T SMB Broadband Router User Guide There are two ways to reset the router: Method one: Use the Factory Defaults function on System Tools -> Factory Defaults page in the router's Web-based Utility. Method two: Use the Factory Default Reset button: Press the Reset button for five seconds and then wait for the router to reboot. ) Note: Ensure the router is powered on before it restarts completely. ¾ WAN: One RJ45 port for connecting the router to a cable, DSL modem or Ethernet ¾ LAN: Eight 10/100/1000Mbps RJ45 port for connecting the router to the local PCs 2.1.2 The Rear Panel The rear panel of the TL-R480T only features a power receptacle, which is an AC power receptacle. Connect the female of the power cord head here, and the male head to the AC power outlet. Figure 2-2 220V~ 50Hz 0.1A 2.2 System Requirements ¾ Broadband Internet Access Service (DSL/Cable/Ethernet) ¾ One DSL/Cable modem that has an RJ45 connector (It's not necessary if you connect the router to Ethernet) ¾ Each PC on the LAN needs a working Ethernet Adapter and an Ethernet cable with RJ45 connectors ¾ TCP/IP protocol must be installed on each PC ¾ Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator 6.0 or later 2.3 Installation Environment Requirements ¾ Not in direct sunlight or near a heater or heating vent ¾ Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on all sides of the router ¾ Well ventilated (especially if it is in a closet) ¾ Operating temperature: 0℃~40℃ (32℉~104℉) ¾ Operating Humidity: 10%~90%RH, Non-condensing ) Note: Do not use this product near water, for example, in a wet basement or near a swimming pool. Avoid using this product during an electrical storm. There may be a remote risk of electric shock 3