Tanaka TCS33EB16S Manual - Page 8
Assembly, Procedures, Warning
View all Tanaka TCS33EB16S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
English ASSEMBLY PROCEDURES WARNING Never try to start engine without side case, bar and chain securely fastened. 1. Pull the front hand guard (2) toward the front handle to check that the chain brake is disengaged. (Fig. 2) 2 5. Guide the chain drive links into the bar groove all around the bar. 6. Install the side case (3) onto the bolts (7). Make sure that the boss of chain tension adjust bolt (10) fits into the hole of the bar (11). (Fig. 5) Then tighten the guide bar clamp nuts (4) by hand that allows the chain bar end to move up and down easily. (Fig. 6) 4 Fig. 2 2. Remove guide bar clamp nuts (4). Remove the side case (3) (Fig. 3) Fig. 6 7. Raise the bar end, and tighten the saw chain (9) by turning the tension adjustment bolt (12) clockwise. To check proper tension, lightly lift up the center of chain and there should be about 0.02 - 0.04" (0.5 - 1.0 mm) clearance between bar and edge of drive link (13). (Fig. 7, 8) 3 4 Fig. 3 * In case of installing the spiked bumper (5), install the spiked bumper (5) (if so equipped) to the unit with two screws. (Fig. 4) 5 12 9 Fig. 7 Fig. 4 3. Install the guide bar (6) onto the bolts (7), then push it toward the sprocket (8) as far as it will go. (Fig. 5) 4. Confirm the direction of saw chain (9) is correct as in the figure, and align the chain on the sprocket. (8) (Fig. 5) 9 7 8 0.02 - 0.04" (0.5 - 1 mm) 13 Fig. 8 CAUTION PROPER TENSION IS EXTREMELY IMPORTANT 8. Raise the bar end and securely tighten the guide bar clamp nuts (4) with the combi box spanner (14). (Fig. 9) 4 11 6 10 8 Fig. 5 14 Fig. 9