Toshiba A20-S259 Maintenance Manual - Page 290
Installing the LCD Module, LCD Module
View all Toshiba A20-S259 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 290 highlights
4.28 LCD Module 4 Replacement Procedures Installing the LCD Module To install the LCD module, follow the steps below and refer to figures 4-40 and 4-41. 1. Secure the two metal braces to the LCD module with the following screws. • M2×3 SUPER FLAT screw ×4 2. Lean the LCD module against the lower side of the display cover. 3. Connect the LCD cable to the LCD module. 4. Stick the grass tape on the LCD cable. 5. (For SXGA+ models only) Stick the copper tape on the LCD cable. NOTE: When sticking the copper tape, make sure the copper part of the copper tape is in the center position of the LCD cable. 6. Seat the LCD module and secure it with the following screws. • M2×5 SUPER FLAT screw ×4 CAUTION: Make sure the cables lie inside the guide. Be careful not to damage or pinch any cables when you seat the LCD module. Satellite A20 Maintenance Manual (960-444) 4-73