Toshiba A20-S259 Maintenance Manual - Page 66
Procedure 3, Connection Check, Perform Check 1. - ac adapter
View all Toshiba A20-S259 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
2 Troubleshooting Procedures 2.3 Power Supply Troubleshooting Procedure 3 Connection Check The power supply wiring diagram is shown below: AC power cord AC adapter AC adapter cord System board Battery pack Any of the connectors may be disconnected. Perform Check 1. Check 1 Disconnect the AC power cord from wall outlet. Check the power cable for breaks. If the power cord is damaged, connect a new AC power cord. If there is no damage, go to Check 2. Check 2 Make sure the AC adaptor cord and AC power cord are firmly plugged into the DC IN 15 V socket, AC adaptor inlet and wall outlet. If these cables are connected correctly, go to Check 3. Check 3 Use a multimeter to make sure that the AC adaptor output voltage is close to 15 V. If the output is several percent lower than 15 V, go to Check 4. If the output is close to 15 V, go to Check 5. Check 4 Connect a new AC adaptor or AC power cord. • If the DC IN LED does not light, go to Procedure 5. • If the battery LED does not light, go to Check 5. Check 5 Make sure the battery pack is installed in the computer correctly. If the battery is properly installed and the battery LED still does not light, go to Procedure 4. 2-16 Satellite A20 Maintenance Manual (960-444)