Viper 5904 Owner Manual - Page 41
Last Trigger Report, Nuisance Prevention NPC - reset
View all Viper 5904 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Zone # (led flashes) 1 2 3 4 5 6 Table of Zones Zone Name Trunk Shock Sensor Door Optional Sensor Ignition Hood Last Trigger Report The Last Trigger report displays the two most recent alarm triggers depending on the system state when requested. When disarmed, the report will display screens for the two most recent Alarm Zone triggers since the vehicle was last driven. When armed, the report will display screens for two most recent Alarm Zone triggers since the system was armed. Note The last trigger report clears when ignition is turned on. Nuisance Prevention (NPC) NPC monitors all alarm zones and, if any are triggered excessively, bypasses them until corrected. If a point of entry (trunk, hood, door) is left open following a forced entry, it is bypassed. It becomes active again only after being closed. Sensors that trigger excessively are bypassed and reported to the remote via Sensor Status icon in the Status Screen, and by NPC On screens that are displayed during the Disarm Trigger and Last Trigger reports. Bypassed sensors automatically reset after one hour and after the vehicle is driven. Disarming then re-arming the alarm does not reset bypassed sensors. 38 © 2011 Directed Electronics. All rights reserved.