Viper 5904 Owner Manual - Page 49

Valet Mode Valet mode can be entered and exited by performing the Remote Valet command or manually using the vehicle key and the control button. When entered, the alarm functions are defeated while the convenience features still operate normally. Arm and Disarm commands lock and unlock the doors while the LOCKED IN VALET and UNLOCK IN VALET animations and beeps play to confirm. Use the following steps to manually enter and exit Valet Mode: 1. Turn the ignition switch On and then Off 2. Immediately press and release the control button once 3. The control center LED turns On when entering and Off when exiting. Power Save To reduce power consumption the control center status LED modifies its output if the vehicle is parked for an extended period. If Armed the flashing is reduced after 24 hours. When Valet mode is On, the LED turns off after 1 hour and resets each time the ignition is turned off. Rapid Resume If power is ever disconnected by a mechanic or thief, the system will resume the state it was in at the time of disconnection, when power is reconnected. Automatic Remote Updates The system sends a silent message to all remote controls after any major action has occurred. When the remote receives this message it updates the status screen icons. This way all users are able to quickly review the system status just by accessing the status screen. 46 © 2011 Directed Electronics. All rights reserved.