Weider 9000 Uk Manual - Page 13

26. Wrap the Low Cable (33) around a 90mm Pulley 26 (24). Attach the Pulley and a Cable Trap (26) to the second hole from the bottom of the two Pulley Plates (28) with an M10 x 45mm Bolt (57) and an M10 Nylon Locknut (49). 27. Attach the end of the Low Cable (33) inside the 27 hole in the Rear Upright (6) with an M10 x 65mm Bolt (54), two M10 Washers (52) and an M10 Nylon Locknut (49). 28. Attach the Backrest (13) to the Centre Upright (5) 28 with two M6 x 63mm Bolts (56) and two M6 Washers (59). Before using the weight rack, pull each cable a few times to be sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on page 20 for proper cable routing. If there is any slack in the cables, they will need to be tightened; see TROUBLESHOOTING AND MAINTENANCE on page 21. 28 49 26 57 24 33 33 6 52 49 54 5 56 59 56 13 13