Weider 9000 Uk Manual - Page 9

11. Identify the Right and Left Butterfly Arms (11, 12) by noting the positions of the welded brackets. Press two 45mm Square Inner Caps (42) into the ends of the Left Butterfly Arm (12). Wet the bottom end of the Butterfly Arm with soapy water. Slide a Large Foam Pad (18) onto the end of the Butterfly Arm. Lubricate the axles on the Top Frame (8) with grease. Orient the Left Butterfly Arm (12) as shown and slide it onto the left axle so that it is behind the bracket on the Top Frame. Have a second person secure the Butterfly Arm with two 1" Retainers (35) and a 1" Cover Cap (36). Note: Place the Retainers on top of the included retainer tool, as shown in the inset drawing. Make sure the teeth on the Retainers bend toward the tool. Gently tap the tool onto the axle. Remove the tool, and tap the Cover Cap onto the axle. Repeat this step with the Right Butterfly Arm (11). 11 Axle 35 Retainer Tool Bracket 8 11 42 35 36 Lubricate Axle Welded Bracket 12 42 18 12. Press a 25mm Round Inner Cap (45) into the 12 upper end of a Storage Tube (22), as shown. Attach the Storage Tube (22) inside the hole in the Right Base (1) with an M8 x 65mm Bolt (51), two M8 Washers (53), two 13mm x 12mm Spacers (38), and an M8 Nylon Locknut (48). Repeat this step with the other Storage Tube (not shown) and the Left Base (2). 13. Identify the Butterfly Cable (32), which has an 13 eyelet on each end. Attach one end of the Cable to the bracket on the Left Butterfly Arm (12) with an M8 x 22mm Shoulder Bolt (60) and an M8 Nylon Locknut (48). 45 22 48 53 Hole 38 1 38 53 51 2 48 32 60 12 Bracket 9