Weider 9000 Uk Manual - Page 8

7. Slide the Carriage Stop (19) onto the Rear 7 Upright (6). Make sure that the Carriage Stop is oriented so the Carriage Stop Bushing (20) and the indicated hole are in the positions shown. Attach the Carriage Stop to the hole near the bottom of the Rear Upright with an M8 x 70mm Bolt (58) and an M8 Nylon Locknut (48). Press two 25mm Round Inner Caps (45) into the tube on the Weight Carriage (10). Insert an M10 x 19mm Bolt (61) into the bracket on the Weight Carriage. Slide the Weight Carriage onto the Rear Upright (6). Be sure the bracket is on the side shown. 8. Press three 50mm Square Inner Caps (43) into 8 the indicated ends of the Top Frame (8). 43 45 10 45 61 20 19 Hole 48 6 58 43 8 43 9. Attach the Top Frame (8) to the Crossbar (7) with 9 two M10 x 68mm Bolts (46), two M10 Washers (52), and two M10 Nylon Locknuts (49). Attach the Top Frame (8) to the Centre Upright (5) with two M10 x 68mm Bolts (46), two M10 Washers (52) and two M10 Nylon Locknuts (49). Do not tighten the M10 Nylon Locknuts (49) yet. 10. Attach the Top Frame (8) to the Rear Upright (6) 10 with three M10 x 68mm Bolts (46), two Support Plates (14), and three M10 Nylon Locknuts (49). Tighten the M10 Nylon Locknuts (49) used in steps 2-10. 8 46 52 46 8 49 7 49 52 5 49 14 49 14 8 46 6