Whirlpool ECKMF94 Installation Guide - Page 10

Installing the tubing clips Refer to the side diagram for the following steps. 1. Remove the seven hex-head screws from the rear access cover, then remove the cover and set it aside. NOTE: If you have a later unit with a metal panel, (see DETAIL A), remove the hexhead screw from the access cover. Discard the cover and its screw. Do not remove the 7 hex-head screws from the larger rear access cover. 2. Peel the backing from the adhesive sides of the tubing clips. Press the clips against the back of the cabinet in the right channel at the approximate locations shown in DETAIL B. Center the clips between the fill tube (an alternate fill tube design is shown in DETAIL C) and the top of the access opening. If you have a bottom freezer, proceed to page 11. If you have a side-by-side (SXS) or a top freezer unit, proceed to page 12. DETAlL C Fill tube for b freezer mode Fill tube for top and SXS freexerr only Right channel / rDETAlL B 9 Tubing clio Top and SXS freezers Tubing CliD Bottom freexere 18xacces8 cover DETAlLA - Installing the tubing clips 10