Whirlpool ECKMF94 Installation Guide - Page 25

Troubleshooting Operational notes i.The Ice Maker water valve contains a flow washer that acts like a pressure regulator to control the water flow. For the Ice Maker to work properly, the water pressure in your home must be between 20 and 120 pounds per-square-inch (psi). If you encounter problems with your Ice Maker's ability to produce ice, call your water utility company and have the water pressure checked. 2. The Ice Maker's water valve is equipped with two strainers: a plastic basket type and a wire-mesh screen. Both of these can be cleaned by turning off the water and disassembling the water valve (your service center should be able to provide this service). If local water conditions require periodic cleaning, or if you use a well as a water source, you should consider installing a second water strainer in the water line. You can obtain a water strainer from your local appliance dealer. Troubleshooting chart The following chart lists several common problems that could occur with your Ice Maker. PROBLEM One or more of the following sounds is heard: l Buzzing l Trickling water l Thud (clatter of ice) Ice tastes stale. Water in Ice Maker overflows. Not enough ice. Ice making has stopped. CAUSE The water valve is operating. Water is entering the Ice Maker fill cup. Ice is being dumped into the ice bin. The ice is old. Make a new batch. Refrigerator or Ice Maker is not level. If the Ice Maker still overflows after leveling, turn off the Ice Maker's water supply at the shut-off valve, and raise the Ice Maker's bail arm to the "off" position (see page 24); then contact your local service center. Freezer door is being opened too often. Adjust the Air Control or Freezer Control for a colder setting. Be sure that the bail arm is lowered into the ice bucket (see page 24). Make sure that the water shut-off valve is on. The water shut-off valve or the water valve screen is clogged (contact your local service center). 25