Whirlpool ECKMF94 Installation Guide - Page 9

Top/bottom freezer models Refer to the side diagram for the following steps. 1. Remove the phillips screw from the ice maker wiring cover, unhook the right side tab from the edge of the back cover, and remove the wiring cover. Mounting hole - Phillips 2. Look at the back side of the wiring cover screw and note the grooved lines. Use a pair of pliers and bend the areas inside the Tab grooved lines back and forth until they Wiring break away from the wiring cover. Refer to the side diagram for the following steps. 1. Pull the 4-wire ice maker harness out from behind the freezer's back cover as far as possible, and hang it over the edge of the cutout. Do not remove any other wiring from the cutout. 2. Slide the flared end of the short aluminum fill tube extension or the short plastic fill tube extension over the end of the fill tube as far as it will go (see DETAIL A). 3. Refer to DETAIL B and install the wiring cover over the fill tube with the wiring harness through the slot. Hook the tab in the side of the wiring cover into the slot in the back cover of the freezer, and secure the cover with the phillips screw you removed earlier. Removing the wiring panel DETAlL A d 14 extension ab Installing the short fill tube extension and reinstalling the wiring panel