Xerox Z750/N Setup Guide - Page 28

Setting the Printer's IP Address Note When two or more IP address methods are used simultaneously, the printer uses the first address that it successfully obtains. Information needed for IP addressing Information Internet (IP) address for the printer Network mask Default Router/Gateway address Broadcast address Comments Format is x.x.x.x, where x represents a decimal number from 0 - 255. If you are unsure, leave this blank; the printer will choose an appropriate mask. Router address. You need this address if you want to communicate with the printer from anywhere other than the local network segment. This is the address the printer uses to send broadcast packets. Regardless of how this parameter is set, the printer accepts broadcast packets from any of the commonly used broadcast address conventions. It should not be necessary to set this address, because the printer calculates it automatically. However, you can override the default setting. Setting the IP address from the Phaser 750 front panel 1. When the front panel displays Ready, press the Menu button. 2. Press the right-arrow (---->) button until Configuration is displayed. Press the Menu button. 3. Press the right-arrow (---->) button until Network Settings is displayed. Press the Menu button. 4. Press the right-arrow (---->) button until TCP/IP is displayed. Press the Menu button. 5. Set the IP address: a. Press the right-arrow (---->) button until TCP/IP Address is displayed. Press the Select button. b. Press the right-arrow (---->) button to highlight the part of the address that you want to set. Press the + button to change the numbers. c. When the address is correct, press the Set button. d. Press the Confirm button. Networking Setup Guide 23