Xerox Z750/N Setup Guide - Page 47
Determining which protocols are enabled
![]() |
UPC - 042215455084
View all Xerox Z750/N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Disabling and Enabling Protocols Disabling and Enabling Protocols After your network configuration is complete, you may want to disable protocols that you are not using to avoid unnecessary network traffic. There are four ways to disable protocols: I Use the printer's front panel; see Disabling and enabling protocols: Phaser 750 front panel on page 43. I In NetWare environments, you can use the PhaserShare Administrator; see Disabling protocols: PhaserShare Administrator on page 43. I With a TCP/IP connection and a World Wide Web browser, you can use PhaserLink Printer Management Software; see Disabling protocols: PhaserLink Printer Management Software on page 44. I Send the appropriate PostScript utility file to the printer. See the README files on the printer's CD-ROM. The PC README file is in the UTILS directory; the Macintosh README file is in the Network Utilities folder. You can enable protocols by the same procedures; just select the command to enable a protocol rather than disable it. Determining which protocols are enabled All protocols can be enabled and disabled. The Configuration Page reports which protocols are enabled. If a protocol is enabled, the field for that protocol lists the current parameters. If the protocol is disabled, the field for that protocol contains an entry reading Disabled. 42 Phaser 750 Color Printer
![](/manual_guide/products/xerox-z750n-setup-guide-9fef307/47.png)