Yamaha CS1x Owner's Manual - Page 26

Common Edit 2 (applied to all Layers) This row provides functions and parameters which are common to all Layers in a Performance (except for "Portament"), including the settings for realtime controllers such as the Pitch Wheel, Modulation Wheel and Foot Controller. DEMO PERFORMANCE MULTI STORE UTILITY ARPEGGIATOR TYPE TEMPO SUB DIVIDE P BEND MW RANGE PMOD FMOD PERFORM LEVEL CUTOFF TUNE NOTE NOTE DETUNE LIMIT LIMIT SFT LOW HIGH AEG ATK DCY DCY REL TIME TIME LEVEL TIME FEG ATK DCY DCY REL TIME TIME LEVEL TIME BANK PROGRAM VOLUME PAN REV TYPE FMOD LIMIT LOW AMOD INIT LEVEL REV SEND EFECT PERFORM CHO VARI VARI VARI NAME TYPE TYPE PARAM DATA FC PORTA ASSIGN1 CUTOFF VARI SWITCH TIME PARAM EF VEL ASSIGN2 LIMIT OFFSET DEPTH PARAM DATA HIGH LFO PMOD FMOD WAVE SPEED PHASE INIT PEG ATK ATK DCY REL REL TIME LEVEL TIME TIME LEVEL EFFECT FILTER POLY/ CHO VARI CUTOFF REZ MONO SEND SEND COMMON LAYER s P BEND RANGE (Pitch Bend Range) This sets the Pitch Bend range in semitones. The pitch can be bent up or down within the range set here by moving the Pitch Wheel. Settings: -24 ~ +24 semitones s MW (Modulation Wheel) This sets the control parameters of the Modulation Wheel. There are three parameters: PMOD (Pitch Modulation), FMOD (Filter Modulation) and CUTOFF (Cutoff). The parameters set here can be controlled with the Modulation Wheel to add vibrato or tremolo effects to the sound. Pitch Modulation Filter Modulation Cutoff PMOD (Pitch Modulation): Sets the pitch modulation depth created by the LFO (Low Frequency Oscillator). The value set here will determine the range of the pitch modulation by the Modulation Wheel. Moving the Modulation Wheel up will increase the depth of the pitch modulation, while moving it down will decrease the depth. FMOD (Filter Modulation): Sets the filter modulation depth created by the LFO (Low Frequency Oscillator). The value set here will determine the range of the filter modulation by the Modulation Wheel. Moving the Modulation Wheel up will increase the depth of the filter modulation, while moving it down will decrease the depth. CUTOFF (Cutoff): Sets the range of the cutoff frequency points above which the other frequencies are cut off. The value set here will determine the range of the cutoff frequency points when using the Modulation Wheel. Moving the Modulation Wheel up will raise the cutoff frequency point (i.e., make the voice brighter), while moving it down will lower the cutoff point (i.e., make the voice darker). Settings: PMOD (Pitch Modulation): 0~127 FMOD (Filter Modulation): 0~127 CUTOFF: -64 ~ +63 25