Yamaha CS1x Owner's Manual - Page 39

s PAN This sets the panning (the left or right position in the stereo spectrum) for each Part. Different pannings can be set for each Part (for stereo output). Settings: Random, L63 (far left in the stereo image) to L01 to C00 (center of a stereo image) to R01 to R63 (far right in the stereo image) NOTE When set to "Random", the panning of each Part will alternate between left and right each time a voice is played. NOTE Some of the voices are preset and fixed to a panning of "left" in the lower register and "right" in the higher register. In such a case, you cannot modify the pan setting. s EFFECT This sets the effect send (output) level for each Part. There are three parameters: REV SEND (Reverb Send), CHO SEND (Chorus Send) and VARI SEND (Variation Send). You can change the effect send level for each effect in realtime when you are playing back XG song data containing effect settings using an external MIDI device. NOTE When you enter Multi Play mode (reset to XG ON) by pressing the MULTI button, each effect will be reset to the default settings: Hall 1 (Reverb), Chorus 1 (Chorus) and Delay L,C,R (Variation). In this case, the Reverb send level is set to 64, and the Chorus and Variation send levels are set to 0. Depending on the XG song data being played, the effect types and their parameters used in the song may differ. Note that the effect types and their parameters in the Performance Edit mode have no relation to the effect settings here. Reverb Send Chorus Send Variation Send REV SEND (Reverb Send): Determines the send level of the Reverb effect. CHO SEND (Chorus Send): Determines the send level of the Chorus effect. VARI SEND (Variation Send): Enables or disables the output of the Variation effect. Settings: REV SEND (Reverb Send): 0~127 CHO SEND (Chorus Send): 0~127 VARI SEND (Variation Send): OFF, ON (or 0~127) NOTE The Variation send parameters are OFF or ON when the Variation effect is used as the Insertion effect. They are 0~127 when used as the System effect. Normally, the Variation effect works as an Insertion Effect when not receiving parameter change messages to switch to System Effect from an external MIDI sequencer. For more information about Insertion and System effects, see page 47. s FILTER This sets the parameters of the filter for each Part. There are two parameters, CUTOFF and REZ (resonance). Cutoff Resonance 4 DEF 1 ABC 0 Generally, filters change the timbre by passing signals within a specific frequency bandwidth and cutting others. The CS1x features an LPF (Low Pass Filter) which passes the signals below the specified frequency point (cutoff frequency) and cuts the signals above it. NOTE Depending on the voice selected, changing certain parameters may not produce a noticeable effect. CUTOFF: Determines the cutoff frequency of the filter, or the frequency point above which other frequencies are filtered out. Higher settings result in brighter sounds and lower settings result in darker sounds. REZ (Resonance): Sets the amount of filter resonance or emphasis around the cutoff frequency. Higher settings produce a higher resonant peak, while lower settings produce a relatively flat response. Settings: CUTOFF: -64 ~ +63 REZ (Resonance): -64 ~ +63 38