Yamaha QL5 Ql Editor Owner's Manual - Page 65

8 Input meter Indicates the level of the signal being input to the internal effect. 9 Output patch Click the L CHANNEL or R CHANNEL area, and choose one of the following as the signal route that will be patched to the L/R output channels of the internal effect. NONE No assignment CH 1-64 (CH 1-32 on the QL1) INPUT CH 1-64 (CH 1-32 on the QL1) STIN1L-STIN8R ST IN channel 1-8 (L/R) INS1 CH1-CH64 (CH 1-32 on the QL1) Insert-in 1 of INPUT CH1-64 (1-32 on the QL1) INS1 MIX1-MIX16 MIX channel 1-16 insert in 1 INS1 MTRX1-MTRX8 MATRIX channel 1-8 insert in 1 INS1 ST L, INS1 ST R, INS1 M(C) Insert-in 1 of STEREO channel L/R or the MONO channel INS2 CH1-CH64 (CH 1-32 on the QL1) Insert-in 2 of input channel 1-64 (1-32 on the QL1) INS2 MIX1-MIX16 MIX channel 1-16 insert in 2 INS2 MTRX1-MTRX8 MATRIX channel 1-8 insert in 2 INS2 ST L, INS2 ST R, INS2 M(C) Insert-in 2 of STEREO channel L/R or the MONO channel The channel name is shown in the boxes immediately below. 0 Output meter Indicates the level of the signal being output from the internal effect. A Parameter display select button If "REV-X HALL," "REV-X ROOM," "REV-X PLATE," or VCM effect is selected as the effect type, this button switches between the standard parameter screen and a dedicated GUI screen. B MIX BALANCE Adjusts the balance of the effect sound relative to the original sound. 0 (%) outputs only the B original sound, and 100 (%) outputs only the effect sound. C TEMPO If a tempo-type or modulation-type effect is selected, this allows you to adjust time-related parameters such as DELAY (delay time) and FREQ. (modulation speed.) To set the value of the TEMPO parameter, you can either input the BPM (Beats Per Minute) in the numerical box, or repeatedly click the TAP TEMPO button at the desired tempo. If the MIDI CLK button is on, the TEMPO parameter value will synchronize to the MIDI timing clock being received from the MIDI port. C 65 QL Editor Owner's Manual